Search site
»

Speed humps

There are regulations governing the layout of speed control humps and the consultation procedures. There must be a form of "slowing feature" - usually formed by a change of priority (traffic entering the system has to turn sharp left or right into the road, or has to "give way". Sometimes mini roundabouts are used at the start of a system of humps.

The shape of speed control humps are strictly regulated. They must be between 50mm and 100mm high, at least 2.75m long and extend over the full width of the road, except for a drainage channel at either end. They may have either flat tops or round tops. Many local authorities have adopted the 75mm high hump as a standard. This is because it has been found to reduce traffic to around 22 mph. The 100 mm high humps reduce speeds to 17 mph on the hump but speeds rise to 35 mph between the humps, causing excessive acceleration, braking and increased pollution. Flat topped humps can be of any length and are often known as "speed tables". They are sometimes used to reduce the impact on long wheel base vehicles such as buses.

Speed control humps can lead to complaints about increased noise and sometimes increased vibration from traffic. They have however been proved to reduce traffic speed and they have been installed in many locations.

The image below is of an existing speed table in Water Lane, Totton.

Speed humps

For further information contact:

Transportation Section
Appletree Court
Beaulieu Road
Lyndhurst
Hampshire
SO43 7PA

email  traffic@nfdc.gov.uk

Updated: 18 Nov 2014
Powered by GOSS iCM